Hey guys ,
So I went to MSW for an aggressive wheel alignment after I replaced "
1.Subframe Bushes
2.Front Diff bushing
obviously the Carrier was dropped for this job . Once complete and up on a the Alignment at MSW the Camber on the rear is Way off
-0.6 LEft
-0.9 Right
The Usual Camber For our Cars sit at -2.5 to -1.5 if im not mistaken which I am at least -1.0 out of camber basically the rear tyres are tilted to the outside and the thread is not eating whatsoever hence the poor handling
the guys tried retorqing the camber bolt and it was set to maximum.I then discovered that the Bolt Washer was fully Worn Out and got it replaced for both left and right Camber Bolts , went back to MSW and still got the same result only this time the left went to -0.7 and -1.0(-0.1 Improvement)
What can cause this headache ?
1.Bent WishBones ?(lower arms ?)
2.Eliminated the Fact that I had Bad washers
Car has never had any sort of accidents whatsoever as per FSH @AGMC
Help is appreciated Guys
P.s Castor and Toe are OK
THe OTher issue I have is that the car keeps Pulling to right even after a front alignment but im guessing that's due to the bad CAmber adjustment at the rear
I`ve Put out an order for New Lower Arms .
I don't want to go ahead and buy after market Adjustable Lower arms if theres an actual issue with the car
Please let me know if anyone has encountered this before and how did it get resolved
Car is 2006 M3 E46
So I went to MSW for an aggressive wheel alignment after I replaced "
1.Subframe Bushes
2.Front Diff bushing
obviously the Carrier was dropped for this job . Once complete and up on a the Alignment at MSW the Camber on the rear is Way off
-0.6 LEft
-0.9 Right
The Usual Camber For our Cars sit at -2.5 to -1.5 if im not mistaken which I am at least -1.0 out of camber basically the rear tyres are tilted to the outside and the thread is not eating whatsoever hence the poor handling
the guys tried retorqing the camber bolt and it was set to maximum.I then discovered that the Bolt Washer was fully Worn Out and got it replaced for both left and right Camber Bolts , went back to MSW and still got the same result only this time the left went to -0.7 and -1.0(-0.1 Improvement)
What can cause this headache ?
1.Bent WishBones ?(lower arms ?)
2.Eliminated the Fact that I had Bad washers
Car has never had any sort of accidents whatsoever as per FSH @AGMC
Help is appreciated Guys
P.s Castor and Toe are OK
THe OTher issue I have is that the car keeps Pulling to right even after a front alignment but im guessing that's due to the bad CAmber adjustment at the rear
I`ve Put out an order for New Lower Arms .
I don't want to go ahead and buy after market Adjustable Lower arms if theres an actual issue with the car
Please let me know if anyone has encountered this before and how did it get resolved
Car is 2006 M3 E46
Comment